XI CHENG Engineering Team - Industrial Air Pollution Control Equipment Manufacturer

Cyclonic Spray Tower: Industrial Scrubber Guide

A plant engineer looking at a standard spray tower’s limitations faces a specific problem: the gas velocity cannot exceed approximately […]

A plant manager watching acid gas emissions approach the permit limit has two choices: install more mass-transfer surface area, or

An engineer evaluating air pollution control equipment does not start by picking a scrubber type. The engineer starts with the

Spray Tower Design: Design, Operation, and Selection Guide Every spray tower scrubber installation that underperforms can be traced back to

Every engineer who has specified air pollution control equipment has faced the same decision: do you need the highest possible

Introduction A wet scrubber can be perfectly designed with the correct column diameter, packed height, and L/G ratio, yet still

Introduction Your wet scrubber was designed for 99 percent removal efficiency, but the last three stack tests showed 96, 94,

Introduction Your scrubber was designed to remove 99 percent of the target pollutant, but the outlet concentration readings show 92

Introduction Your existing wet scrubber is not performing like it used to. Pressure drop has increased by 30 percent compared

Introduction You need a wet scrubber for a corrosive gas stream containing HCl, H2SO4, or Cl2. The operating temperature is